Some of our customers

European Space Agency-Philips Eindhoven-Oslo University-Tel Aviv Uni-Univ Colorado-Glasgow Univ. BMW-VW-Max Planck Inst-Ultra Cold Lab Singapore-Skolkovo Uni Moscow-ETH Zürich. Universites in the following countries: Sweden, Denmark, Germany, France, England, Italy, CH, Turkey, KSA (Saud), Egypt, Israel, India, China, Tawian, Japan, Peru , Australia, New Zealand, South Africa, Scotland.
Special thanks to all individuals and companies who invested in our products.
Thank you for help and feedback in our “bleeding edge”, Karl Heinz  and R*  in Germany, Seb in Spain, Arthur in Haifa, Gregor and Stefan in CH, Didier, Thomas, Alexandra, Robinson, Uwe, Ulf, Sascha, Uorschla, and many more..

Yes! It is a direct drop – in replacement.

Your “old” nozzles will work just like before, with the new block.

Category: Installing


There is not one reason to do so, except theoretically:

The Matchless Block V3 is stealing a few millimeters of the maximum build height, compared to an original UM2.

Category: Installing

If the sensors do not come out in one piece. This applies to the Temp Sensor cartridge and sometimes the Heater cartridge.

In 10-20% of the cases users are unable to get the temp sensor (3mm diameter) out of the standard hot end. By pulling its cables it is destroyed.

In fewer cases the heater cartridge (4mm diameter) is also destroyed.
EXPERTS will still have a good chance of recovering the cartridges, by carefully drilling a 2-3mm diameter hole from the opposite end, of maximum 4.95-5mm (varies) . This will enable you to push the old sensor/heater out, if it is not destroyed by the drill bit.

The cause of this predicament is a manufacturing glitch in the hot end / sensor size. It is also caused by the hot flooded by leak because of a collapsing Teflon piece and broken Steel coupler (the grey one with the tiny radial holes). If the hot end is allowed to print or stay hot for some time (minutes or hours) the flooded filament is carbonized and gets very hard.

The cartridges will not be recoverable in such cases.

Category: Installing

7 minutes if you did it before, 20 minutes otherwise.
You will need the tiny hex tools which came with your printer when you bought it.
The kit from 3D Solez ships with the other necessary tools.

Category: Installing

You need the tools that came with your Ultimaker to uninstall the existing block.

The kit comes with the tools need to install the V3 Matchless block, and to. change the nozzles when you want.

Category: Installing

Load More